Carrier Access Network Device Axxius 800 Bedienungsanleitung PDF herunterladen (Seite 255)

100

101

Axxius 800 - Release 2.2 5-155

CLI Commands

set

set (router-wan) ip

Use the set (router-wan) ip command to set the IP traffic handling on the WAN interface.

Syntax: set {rtr_card-addr} {"wan-name"} ip

{block|bridge|route}

Example: set 1 "LosAngeles" ip route

Sets the WAN interface named "LosAngeles" on the Router in slot 1 to route IP.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

{"wan-name"}

The WAN interface to modify. The name must be enclosed in quotes.

{block|bridge|route}

set (router-wan) ip address

Use the set (router-wan) ip address command to set the IP address for a WAN interface.

Syntax: set {rtr_card-addr} {"wan-name"} ip address

{ip-addr} [mask]|unnumbered}

Example: set 1 "LosAngeles" ip address 100.2.2.2 255.255.255.0

The example will set the WAN interface named "LosAngeles" on the Router in

slot 1 to the IP address 100.2.2.2, with a subnet mask of 255.255.255.0.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

{"wan-name"}

The WAN interface to modify. The name must be enclosed in quotes.

{ip-addr}

Router IP address, in the form of xxx.xxx.xxx.xxx, where xxx is between 0-255.

[mask]

The subnet mask, in the form of xxx.xxx.xxx.xxx, where xxx is between 0-255.

{unnumbered}

Treat this as an un-numbered interface, as per RFC 1812.

block Set the WAN to block IP.

bridge Set the WAN to bridge IP.

route Set the WAN to route IP.

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Carrier Access Network Device Axxius 800 Bedienungsanleitung Seite 255

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Carrier Access Network Device Axxius 800