Carrier Access Network Device Axxius 800 Bedienungsanleitung PDF herunterladen (Seite 251)

100

101

Axxius 800 - Release 2.2 5-151

CLI Commands

set

set (router-trunk) speed

Use the set (router-trunk) speed command to specify the data speed for each DS0 in the

given trunk. This command takes effect upon transition of the trunk to active. This

command applies to the TSR card only.

Syntax: set {tsr-trunk-addr} speed {56|64}

Example: set 3:1:23 speed 56

The example will set the data speed of trunk 23 in the TSR in slot 3 to 56 Kbps.

{tsr-trunk-addr}

{56|64}

set (router-trunk) up/down

Use the set (router-trunk) up/down command to set the WAN trunk up or down. When the

Router trunk is set down a link failure will not cause an alarm. This can be used to eliminate

alarms from Router trunks that are not in-use. When the Router trunk is set up, a link failure on

the WAN trunk will cause an alarm to be reported to the Axxius.

Syntax: set {rtr_trunk-addr} {down|up}

Example: set 2:1:1 down

The example will set the first Router trunk interface on slot 2 down.

{rtr-trunk-addr}

{up|down}

slot Slot number (1-8) that contains the TSR card

port Port number of the Router

trunk Trunk number for this port, 1-24

56 56 Kbps data speed

64 64 Kbps data speed. 64 is the default.

slot Slot number (1-8) that contains the Router card

port Port number of the Router

trunk Trunk number for this port, 1-24

down Set the WAN down.

up Set the WAN up.

1 2 ... 246 247 248 249 250 251 252 253 254 255 256 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Carrier Access Network Device Axxius 800 Bedienungsanleitung Seite 251

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Carrier Access Network Device Axxius 800